Discussion:
Hf100r motor dead
(too old to reply)
Lore
2018-03-23 07:32:04 UTC
Permalink
Hi,
I had to dismantle my working 100r in order to restore the cabinet.
I have been quite careful but after puttting it togheter motor is dead.
Ok, 3A fuse blown.
Replaced, blown again...
Now I have to trace the problem. I have the service manual but before starting, any ideas of what is more probably the problem?

Thanks
Lore
Mike Thomas
2018-03-23 14:44:18 UTC
Permalink
Probably bent contacts on reversing switch.

Mike
On Fri, 23 Mar 2018 00:32:04 -0700 (PDT), Lore
Post by Lore
Hi,
I had to dismantle my working 100r in order to restore the cabinet.
I have been quite careful but after puttting it togheter motor is dead.
Ok, 3A fuse blown.
Replaced, blown again...
Now I have to trace the problem. I have the service manual but before starting, any ideas of what is more probably the problem?
Thanks
Lore
Lore
2018-03-23 18:41:53 UTC
Permalink
ahh, right, I finally discovered the contacts on the most left of the reversing switch seem to be shorted. From the manual I see this should be the cancel solenoid ones...
ok, found it opening the top back door, there are two of them.
Now, it seems quite difficult to access them and see what happened without taking out the Whole motor block.
Any clues to unblock the solenoids (maybe for some reason stuck) or should I start to take out the motor block?

Thanks a lot again
Post by Mike Thomas
Probably bent contacts on reversing switch.
Mike
On Fri, 23 Mar 2018 00:32:04 -0700 (PDT), Lore
Post by Lore
Hi,
I had to dismantle my working 100r in order to restore the cabinet.
I have been quite careful but after puttting it togheter motor is dead.
Ok, 3A fuse blown.
Replaced, blown again...
Now I have to trace the problem. I have the service manual but before starting, any ideas of what is more probably the problem?
Thanks
Lore
Loading...